UPSB v3

Pen Modifications / Help with RSVP MMX

  1. jwz
    Date: Tue, Nov 20 2007 23:51:21

    I checked out the Wiki regarding the RSVP MMX.
    When I tryed making it myself, I encountered this problem:

    The threads on the G2 made it impossible to put the G2 onto the RSVP because of the plastic "ring" that holds the RSVP in place.
    (assuming that the threads go first. It seems that way on the picture. Also it says "cut 3.5cm IN FRONT of the clicker")

    Since there is no picture of WHERE exactly you cut the G2, I made up my mind and made a new topic rather than wasting my only G2 left.
    Searched UPSB AND UCPSBv2 for other tuts, couldn't find any.
    Please help.

    (I'm sorry if I shoulda posted this somewhere else. Feel free to delete/close if I should)

  2. xthesaintx
    Date: Wed, Nov 21 2007 00:14:47

    As for putting the G2 onto the RSVP, you should have to sand down the ring on the rsvp and maybe the rest of the grip area of the rsvp so that you can fit the insert and the G2 part on the RSVP, threads first.

    And as for cutting the G2, the wiki says "Cut the back piece of the G2 barrel (in front of the clip) to 3.5cm." which means you cut the part of the G2 barrel to make it 3.5cm, so just measure 3.5cm from the threads and cut there.

  3. jwz
    Date: Wed, Nov 21 2007 00:24:55

    QUOTE (xthesaintx @ Nov 20 2007, 09:14 PM) <{POST_SNAPBACK}>
    As for putting the G2 onto the RSVP, you should have to sand down the ring on the rsvp and maybe the rest of the grip area of the rsvp so that you can fit the insert and the G2 part on the RSVP, threads first.


    Thanks. You just made my day laugh.gif
    (The rest of the tut looked really thorough, so I figured that if I needed to sand, the tut would say so)

  4. Rorix
    Date: Wed, Nov 21 2007 02:44:43

    QUOTE (jwz @ Nov 21 2007, 01:24 PM) <{POST_SNAPBACK}>
    Thanks. You just made my day laugh.gif
    (The rest of the tut looked really thorough, so I figured that if I needed to sand, the tut would say so)


    Read it again, step 8 says:

    QUOTE (Wiki)
    8. Sand down the rings on the front of the RSVP barrel, between the grip area and the tip. This will allow the G2 barrel to slide over the grip area.


    EDIT: Nvm, sketching dry.gif

  5. sketching
    Date: Wed, Nov 21 2007 02:54:05

    I just added that point to the wiki. wink.gif
    I forgot about the sanding part since I just do it without thinking anymore.

  6. Perverted Hermit
    Date: Thu, Nov 29 2007 09:16:53

    I just sand the ring on the rsvp and put the g2 barrel on but the barrel keeps going lose meaning i can move it up and down. How do I make it tight and firm?

  7. Rorix
    Date: Thu, Nov 29 2007 09:44:33

    wikisadob3.gif

    QUOTE (Wiki)
    # Print out an insert to be placed between the RSVP barrel and the G2 barrel, this insert will keep the G2 barrel from sliding off.

    * Insert dimensions for G2 barrel insert: 3.53cm x 3.39cm.