UPSB v3

Temporary Bin / Baaron Comssa

  1. iColor
    Date: Tue, Jan 19 2010 04:12:18

    This is a joke.

    Okay, the Baaron DC, the Baaron SC and finally, the Baaron Comssa!

    No stats yet. Sorry. sad.gif

    The materials you need are:
    Supertips barrel with comssa backplug.
    Double Capped Comssa.

    Sorry for the bad pictures. sad.gif


    Spoiler:
    Step 1: Lay out materials for some serious modding.

    Step 2. Transfer both caps to the supertip barrel.

    Step 3. Take bottom cap from supertips and put it on to the top of the comssa.

    Step 4. Do the same to the other cap.

    Step 4.5. Take the bottom cap off and leave it to the side for a bit.
    Step 5. Take the top cap off.

    Step 5.5! Here's the hard part! Rotate it 180 degrees so the hole is facing up.

    Step 6. Put it on the bottom.

    Step 7. Take the cap you put away and put it on the top.

    And you have created the Baaron Comssa Mod.



    OPTIONAL STEP:
    Apply tape wherever needed. Moar tape = moar spinning effect amirite?


    Sorry if you don't understand, it's a complicated mod to make.

    Make sure you don't mess up step 5.5 because that step is very important. You might wanna use a protractor just in case you want to measure 180 degrees.

    -Why is there no grips?
    Because it doesn't need grips.

    -It looks the same as when I started!
    That's because you probably did Step 5.5 wrong. Use a protractor noob.

    -STEP 4 IS SO HARD!
    Nub, wait 'till you get to step 5.5

    -How'd you know how to make the Baaron Comssa?
    SECRET!

    -Is this a joke?
    No.

    -This is a lie!
    no u is lie.

    Thank you for reading this tutorial. I hope you found it helpful!
    Also, I know I fail.

  2. neix
    Date: Tue, Jan 19 2010 04:27:21

    stupid.. and not funny... fail attempt


    (A minute ago) Sankaku
    --
    attention whore much?

  3. xSpin
    Date: Tue, Jan 19 2010 04:29:37

    Uhhmm...You can gtfo now.