UPSB v3
Pen Modifications / Any-X
-
Date: Tue, Jan 1 2008 00:13:34
I just made an Any-X and the spring works and everything but it just doesn't click...What could be the problem? :\
-
Date: Tue, Jan 1 2008 00:15:55
you could have asked this in the quick modifications thread, is the inktube long enough? did you put in the spring the correct way?
-
Date: Tue, Jan 1 2008 00:16:48
It's possible the small part of the anyball inktube slipped out.
-
Date: Tue, Jan 1 2008 02:26:23
Maybe the ink tube isn't sliding throught the connector piece(between the two barrels) smoothly.....
-
Date: Tue, Jan 1 2008 06:10:19
no no it slides very smoothly, it just doesn't click :\
-
Date: Tue, Jan 1 2008 06:14:38
The clicking mechanism needs to move a certain distance before it will catch and "click" so to say. So if its not clicking that means the mechanism doesnt have enough room to move which could be caused by a couple of things...
-make sure the spring is not fully compressing before it clicks otherwise the squished spring will not allow the mechanism to move far enough.
-make sure the ink tube is short enough and not hitting the metal tip before the mechanism clicks.
edit: you might also want to take out the clicking part and make sure its actually working and not broken. -
Date: Tue, Jan 1 2008 06:30:40
ok i just got it in fact, the profile inktube part was too short!
Thank you guys! -
Date: Tue, Jan 1 2008 07:13:35
arent you suppose to use a rsvp inktube?
-
Date: Tue, Jan 1 2008 07:21:30
Yes but you need to have a short section of the profile's one to make it longer ^^ and that's what was too short ^^