UPSB v3
Tutorials Pending Approval / Ballsign Bic
RSVP Bic + Ballsign
-
Date: Sun, May 11 2008 16:44:41
Material:
1 Gelly Roll body
1 Bic Round Stic cap
1 RSVP cap with RSVP grip inside
1 Signo tip
9 Profile/Anyball grip sections
Somthing to cut with
Optional Insert
step1
Stick the Signo tip onto the Bic Round Stic cap. Should fit but if not tape it.
step2
Put all 9 sections of the grips onto the cap.
step3
Get the Gelly Roll body and cut the skinny part so that only 0.7 cm is left.
step4
put the Bic Round Stic cap onto the part of the body that wasnt cut. (if you have an insert put it in now)
step5
put the RSVP cap onto the cutted side. ( the skinny part should fit perfectly into the grip)
this is how it looks like. its balanced and is 21.6 cm.
-
Date: Sun, May 11 2008 16:54:00
i don't like your color choice but great mod
-
Date: Sun, May 11 2008 17:09:05
Yea it looks like itll work pretty well. Im guna go make one now.
-
Date: Sun, May 11 2008 17:22:55
theres a much easier way to get the signo tip onto the bic cap firmly than just tape:
make a hole on the tip of the cap, then widen it enough to get a bic tip into the hole.
Then, wrap some teflon tape to thicken it and screw on the signo tip.
it might screw up the balance but o well
-
Date: Sun, May 11 2008 17:30:41
Look good, but i dont have parts for it
-
Date: Sun, May 11 2008 22:52:13
nice work^^
-
Date: Wed, May 14 2008 06:23:44
hoho look very very good
well done
and thx for nice tutorial -
Date: Thu, May 15 2008 00:19:43
you got that from my house XD. oh wellz, i wasnt ganna post a tut anyways, and now i use a comssa cap and my superspecialsecret tip.